Amnos NuLink2Me Breakout - Debugger for Nuvoton MCU

• Overview
• Features
• Specifications
• Hardware
• User Guide
  • Examples
• Buy it Now
• Resources
  • Documents
  • Firmware

Overview

The Nu-Link2-Me is a simple debugger and programmer with debug and on-line/off-line programming function, only provided with the NuMaker development board, and can be used independently to develop NuMicro® family microcontrollers. The on-board 16 Mbit SPI Flash allows it able to support off-line programming. Nu-Link2-Me provides virtual COM port (VCOM) function to print out messages on PC.

amnos-nulink2me-breakout-top

amnos-nulink2me-breakout-bottom

Features

• USB 2.0 HS to SWD interface
• SWD interface up to 12 Mbps
• On-line/off-line ISP firmware update : UART
• Hardware setting SWD interface voltage : 1.8V, 3.3 V, 5.0 V
• Virtual COM port

Specifications

• Compatible with Nuvoton Nu-Link2-Me
• Headers for All Avaible Pins, Easy to Use
• Adjusted Output Voltage of DC-DC, Max Output 1A
• USB Type-C Connector, Easy to Connect
• Dimension: 55 x 18 x 5 mm

Hardware

amnos-nulink2me-breakout-pinout

Pin	Description	Note
VDD	System Power +3V3
DATA	2 wire debug: Data or JTAG TMS pin
CLK	2 wire debug: Clock or JTAG TCK pin
RESET	reset pin for target MCU
GND	Ground
SCL / QSPI_SS	I2C Clock or QSPI chip select
SDA / QSPI_CLK	I2C DATA or QSPI clock
RX0 / QSPI_MOSI	UART RX or QSPI Master Out Slave In
TX0 / QSPI_MISO	UART TX or QSPI Master In Slave Out

User Guide

Examples

TBD

Buy it Now

AnalogLamb.Com
Xpulabs.Com

Resources

Documents

Offical Nu-Link2-Me HW
Schematic

Firmware

Offical Nu-Link2-Me FW